Gestern hat mein Bagger normal gearbeitet. Heute morgen konnte ich den Hauptarm nicht heben.
Ich habe den Öldruck auf den Primärkreislauf auf das Steuerventil überprüft. Der Druck betrug etwa 20 bar (ich habe eine 400 bar).
Der Hydraulikzylinder versucht, den Hauptarm zu heben, aber es scheint, dass der Druck auf die beiden großen Hydraulikzylinder unzureichend ist
Andere hydraulische Funktionen scheinen normal zu funktionieren. Nur der Hauptarm ist betroffen.
Die Atlas-Dichtungen sind auf allen Ventilen intakt, außer auf dem Ventil für den Hauptarm.
Ist es möglich, dass ich ein Problem mit Steuerventilblock (steurventilblock) habe?
Ist es möglich, dass das Problem im Primärkreis ist?
Gibt es ein diagnostisches Verfahren für dieses hydraulische Problem?
Irgendwelche Vorschläge wären sehr willkommen.
***********************
Yesterday my excavator was working normally. This morning I was not able to raise the main arm.
I checked the oil pressure on the primary circuit to the control valve. The pressure was about 20 bar (I used a 400 bar gauge).
The hydraulic cylinder tries to lift the main arm but it appears that the pressure to the two large hydraulic cylinders is insufficient
Other hydraulic functions appear to be functioning normally. Only the main arm is affected.
The Atlas lead seals are intact on all the valves except on the valve for the main arm.
Is it possible that I have a problem with control valve block ( steurventilblock ) ?
Is it possible that the problem is in the primary circuit ?
Is there a diagnostic procedure for this hydraulic problem ?
Any suggestions would be very welcome.